The MicroBoom is a 50" carbon fiber rod that can be utilized with
any of the condenser microphones in the Micros series. Lightweight and
able to attach to any microphone stand, the MicroBoom is a problem
solver for many hard-to-reach micing applications including choir,
plays, and orchestra.
The MicroBoom can be used with a choice of
capsules in the Micros series, offering a broad choice of pick-up
pattern and frequency response. High quality shielded cable is used
internally to insure the cleanest audio signal path between the
microphone and the bottom of the boom, which terminates in a mini-XLR
male connector. The stand adapter designed for the MicroBoom allows for
total control over the angle, rotation, and position of the carbon
fiber rod. A metal thumbscrew locks the rod firmly in place. The final
angle and position of the microphone is controlled by using the
flexible metal gooseneck just below the microphone. The MicroBoom
provides an ultra-clean, professional, and elegant appearance on stage
while providing exceptional performance and portability.
The
M1255, a miniaturized condenser microphone with a fully integrated
preamp and detachable cable, is designed with a very high sensitivity
for distance micing. Applications include ceiling mount or table mount
for conferencing, overhead choir micing, location recording, audience
or room micing.
The M1255 has complete immunity from RF
interference caused by cell phones and GSM devices. The M1255, which is
equipped with a cardioid capsule, is also available with hypercardioid,
omni or shotgun capsules, giving the microphone the unique ability to
be used in a wide variety of live, studio and broadcast applications.
Applications
- Choir
- Ensemble vocal
- Theatre
- Orchestral zone micing
- Location recording
- Presentation
- Conference room
Features
- Lightweight, rigid
- Portable, easy to position
- Clean, elegant appearance
- Choice of capsules
- Exceptional sound quality
- No external power adapter needed
- Attaches to any mic stand
- Can be used horizontally or vertically
MicroBoom Specifications
- Material Rod: Carbon Fiber
- Gooseneck: Steel
- Connectors: Brass
- Length: 50"
- Diameter: .20"
- Connectors
Bottom: Mini-XLR Male
Top: Mini-XLR Female
- Weight: 2.5 oz (without mix or clip)
- Finish: Non-reflective black
M1255 Specifications
- Transducer Type: Condenser
- Frequency Response: 80Hz-20kHz
- Polar Pattern: Cardioid (other capsules available)
- Output Impedance: 150 ohms
- Sensitivity at 1k: 34.5 mV/Pa
- Signal/Noise Ratio (A-weighted): 73dB
- Equivalent Noise Level (A-weighted): 21dB
- Maximum SPL @ .5% THD: >/=137.5 dB
- Dynamice Range: 117 dB
- Power Requirements: 48-52 V
- Connector: 3 pin mini-XLRm
- Polarity: Positive pressure on diaphragm produces positive voltage on pin 2 relative to pin 3
- Housing/Finish: Machined brass/powder coat
- Weight: 0.6 oz
- Length: 1.97"
